MC_GroupContinue

This Function Block transfers the motion engine back to the situation before MC_GroupInterrupt was executed. The interrupted motion function block's Busy output remains high and the Active output is set again after MC_GroupContinue outputs 'Done'. For remote hosted robot controllers, this function can be executed if an error occurred while performing a motion sequence. For this situation, the Y_GroupResetAndHold function block must be executed first to clear the error and preserve the motion buffer.

Parameters

*	Parameter	Data Type	Description	Default
VAR_IN_OUT
B	AxesGroup	AXES_GROUP_REF	A logical reference to a group of axes, which contains several additional substructures pertaining to the group.
VAR_INPUT
B	Execute	BOOL	Upon the rising edge, all other function block inputs are read and the function is initiated. To modify an input, change the value and re-trigger the execute input.	FALSE
VAR_OUTPUT
B	Done	BOOL	Set high when the commanded action has completed successfully. If another block takes control before the action is completed, the Done output will not be set. This output is reset when Execute goes low.
E	Busy	BOOL	Set high upon the rising edge of the Execute input, and reset when Done, CommandAborted, or Error is true. In the case of a function block with an Enable input, a Busy output indicates the function is operating, but not ready to provide Valid information. (No Error)
E	CommandAborted	BOOL	Set high if motion is aborted by another motion command or MC_Stop. This output is cleared with the same behavior as the Done output.
B	Error	BOOL	Set high if an error has occurred during the execution of the function block. This output is cleared when 'Execute' or 'Enable' goes low.
E	ErrorID	UINT	If Error is true, this output provides the Error ID. This output is reset when 'Execute' or 'Enable' goes low.

Error Description

See the Function Block ErrorID List.